INSTALLATION

Ready-to-run cartridge

No special installation is required. Make sure the cartridge is powered with for example a phone charger.
The first time you insert the cartridge into your printer it will be recognised as "Black - V2". This means that the universal cartridge is working and ready to be loaded with the resin profile of choice.

The correct insertion order:
1. Insert the cartridge in the printer.
2. Plug the usb adapter with cable into a mains socket.
3. Insert the cable in the cartridge.

It takes about 5 seconds before the cartridge is recognised by the printer

 

DIY Module

Installation instructions can be found here: 20181215_installation.pdf

Instead of drilling holes in the resin compartiment, it is also possible to run the wire from the module to the chip on the side of the cartridge.
This is very handy in case you are not comfortable with drilling holes(risk of leakage) or are using more aggressive resin types.

For this purpose an adapter is available: Adapter V0.2.STL

The module is glued in the adapter and then fixed by glue or double sided tape to the square side of the cartridge top(opposite to the cap).
The wire can then be routed on the edge(see picture) to the bottom compartiment. Use a long piece of thin but wide tape to fix the wire in place.